Tool Attribute WS: What Speeds & Feeds for Renshape?

Tool Attribute WS: What Speeds & Feeds for Renshape?

Question:

What are the speeds and feeds that you use in your classroom while CNC machining?

Answer:

That’s really a loaded question!  It depends on a lot of different variables. With that said, below is a list of speeds, feeds, plunge rates, and general info I use when machining Renshape 440 or 450 in my classroom on an Intellitek Super Prolight 1000. I have used the same numbers consistently on the Benchmill 6000, as well as the ExpertMill. Note: These are conservative. As you should be in your classroom, especially as a first year teacher!

Thanks to Fred Routson for filling this out properly! I then went and added my two cents.

reddownloadCaz Tool Attribute Worksheet

Caz HS Tool Attribute WS

 

 75 total views,  2 views today

CHRIS HURD

JIM HANSON



Chris and Jim CIM
© Copyright 2020
Developed by phan1221

Visits: 3,958,442