Tag: xs

How do you Use a Collet?

Question: I have anxsTECH Router and I can’t get my tools to stay in the tool holder. How do I make it work? Answer: It’s easy, but takes a little work when using a collet on a tool holder. This short video shows you how to “snap” the collet into the nut so the tool...

Continue reading

Setting up the xsTech router

What do you need to know to start throwing chips with Tormach’s new xsTECH router? How to start up & shut down the machine How to install and change tools How to locate the part on the table in X, & Y How to find the end of a tool (Z axis) How to load and run code This 18...

Continue reading

How to hold material in the xsTECH

What’s the best way to hold _____________ in my xsTECH router? From strap clamps to double sided tape, we have it all! Learn how to hold everything including circuit boards, flat stock, and blocks in this video. Can you believe that you can use strap clamps, sticky tape, and all kinds...

Continue reading

Will a vice fit in an xsTECH?

Answer: That’s a fair question. When trying to come up with an aswer though, you’ll have to do a bit of research, as it will depend on what you’re machining. Also, there are many different one’s out there. Luckily Jim did some research for us… maybe this video...

Continue reading

Chris and Jim CIM
© Copyright 2020

Visits: 4,604,546