Tag: command

00 Presentation: Dobot Blockly Programming

Download This presentation is meant to be an introduction to all of the different Blockly commands, and where to find them in the interface. Both Jim and I suggest using this in the classroom as a student resource, rather than a presentation that you go over slide by slide. Just give it to...

Continue reading

DobotStudio: The Basics

Question: How do I get started with DobotStudio? There really isn’t much info out there yet on how to use my Dobot Magician Robotic Arm. Solution: Well, first off, here’s just the tip of the iceberg…. more to be added as I figure stuff out. This robot can be taught and record points...

Continue reading

HOW DO I USE LABELS IN ROBOCELL?

Question: How do I use Labels in Robocell? Solution: A label is used when you want to give robocell a place to jump to in a program. A remark will not work! See below to learn what command to use to make a LABEL!   [youtube_sc url=”https://youtu.be/-PvJ6psB1i4?t=3m17s” width=”800″...

Continue reading

Chris and Jim CIM
© Copyright 2020

Visits: 4,553,831