WHERE’S THE IFJUMP COMMAND IN ROBOCELL?

Question: Where’s the IfJump command in Robocell? Solution: IfJump is used to jump somewhere in a program in robocell. Click on the link below to learn what command to use to make an IfJump! .youtube_sc iframe.yp{display:none;}The Adobe Flash Player is required for video playback.Get the...

Continue reading

HOW DO I BUILD THE LYNXMOTION AL5D ARM?

Question:   The directions on line for building the Lynxmotion arms are not very good. Do you have any tips or tricks to give about building them? Also, aren’t they just cheap toys that won’t last that long?   Solution: First off, let me start by saying I have built or repaired...

Continue reading

HOW DO YOU FIX A SERVO WITH STRIPPED GEARS?

Question: How do you fix a wrist rotate servo with stripped gears? It’s a pain in the butt as well as costly to replace. Answer: See the steps below for an inexpensive and simple solution! Note that te metal gears cost almost as much as the servo; it takes 5-10 minutes to change the gears,...

Continue reading

HOW DO I MAKE SURE MY SERVOS ARE CENTERED?

Question:  How do I make sure my servos are centered before I build my robot? How can I test my servos once it is built? Answer: The I.L.A.R. (It Looks About Right) method works ok, but if you want to be precise, you need a servo driver. This video shows you how to use one to test your servos. One...

Continue reading